What should be paid attention to during the use of cyclone dust collector
Correct operation method of cyclone dust collector in use
1. Preparations before starting the cyclone dust collector
1) Check whether the connecting parts are firmly connected.
2) Check the air tightness, ash leakage and air leakage of the cyclone dust collector and flue, dust collector and ash hopper, ash hopper, ash discharge device and ash conveying device.
3) Close the baffle valve, start the ventilator, and gradually open the baffle valve when there is no abnormal phenomenon, so that the dust collector can pass the specified amount of dust-containing gas.
1) Pay attention to the changes of the easily worn parts such as the inner wall of the outer cylinder.
2) When the temperature of the dust-containing gas changes or the humidity decreases, pay attention to dust adhesion, blockage and corrosion.
3) Pay attention to the change of pressure difference and the state of smoke exhaust. Due to wear and corrosion, the dust collector will perforate, resulting in dust emission, reduced dust removal efficiency, poor smoke color, and pressure difference.
4) Pay attention to the air tightness of each part of the cyclone dust collector, and check the changes in the gas flow rate and dust concentration of the cyclone cylinder.
3. Technical work after cyclone separator operation
1) In order to prevent dust adhesion and corrosion, after the dust removal operation, let the dust collector continue to run for a period of time, and stop the operation of the dust collector until it is replaced by clean air.
2) Dust attached to the inner tube, outer tube and blades, dust in the ash hopper.
3) Repair perforations caused by wear and corrosion.
4) Check the air tightness of each part and replace the seals.
5) The cyclone dust collector should perform routine maintenance on the fan according to the operation manual.
1. Preparations before starting the cyclone dust collector
1) Check whether the connecting parts are firmly connected.
2) Check the air tightness, ash leakage and air leakage of the cyclone dust collector and flue, dust collector and ash hopper, ash hopper, ash discharge device and ash conveying device.
3) Close the baffle valve, start the ventilator, and gradually open the baffle valve when there is no abnormal phenomenon, so that the dust collector can pass the specified amount of dust-containing gas.
1) Pay attention to the changes of the easily worn parts such as the inner wall of the outer cylinder.
2) When the temperature of the dust-containing gas changes or the humidity decreases, pay attention to dust adhesion, blockage and corrosion.
3) Pay attention to the change of pressure difference and the state of smoke exhaust. Due to wear and corrosion, the dust collector will perforate, resulting in dust emission, reduced dust removal efficiency, poor smoke color, and pressure difference.
4) Pay attention to the air tightness of each part of the cyclone dust collector, and check the changes in the gas flow rate and dust concentration of the cyclone cylinder.
3. Technical work after cyclone separator operation
1) In order to prevent dust adhesion and corrosion, after the dust removal operation, let the dust collector continue to run for a period of time, and stop the operation of the dust collector until it is replaced by clean air.
2) Dust attached to the inner tube, outer tube and blades, dust in the ash hopper.
3) Repair perforations caused by wear and corrosion.
4) Check the air tightness of each part and replace the seals.
5) The cyclone dust collector should perform routine maintenance on the fan according to the operation manual.